Which Product Should Be Used When in Waterproofing? The question is of critical importance for those who want to extend the life of the building by choosing the right material. If the right product is not chosen at the right time, the health of the structure will be seriously damaged. Therefore, it is necessary to know the product types and usage times well. So, Which Product is Used When in Waterproofing?

When to Use Sub-Foundation Waterproofing Products?

Bitumen-based membranes are the most frequently preferred products for sub-base insulation. These products are applied just before the concrete is poured. Because the foundation is the structure most exposed to water. However, it is very important that the surface is dry and clean before application. In this way, the material adheres completely to the ground and water penetration is prevented. Sempoly Building Systems The waterproofing products provided by offer professional solutions at this stage.

Which Products Are Preferred for Roof Insulation?

Roofs are constantly under threat from rain and snow water. For this reason, polyurethane-based liquid membrane products are widely used on roofs. These products adapt to cracks with their flexible structure. In addition, thanks to their ease of application, they can be applied to large areas in a short time. However, it is necessary to pay attention to weather conditions during application. Because excessive moisture or precipitation negatively affects performance. Sympoly Contact You can get detailed information from the page.

Which Products Are Applied in Wet Areas?

Cement based for wet areas such as bathrooms and toilets Water insulation mortars are the most suitable solution. These products are applied under the ceramic and prevent water from penetrating the structures below. However, correct application is as important as product selection. The risk of water penetration increases especially in corner joints. For this reason, corners should be supported with special tapes. Sempoly Water Insulation Systems provides technical support on this subject.

Which Insulation Product is Used on Terraces?

Terraces are exposed to both sun and rain. Therefore, liquid membranes with high UV resistance are the ideal solution for terraces. In addition, these products adapt to concrete expansions with their elastic structure. However, the ground slope should be checked before application. Otherwise, water accumulations may occur. For terraces waterproofing solutions is offered with a wide range of products.

When are waterproofing products required in basements?

Basements are the most vulnerable areas against groundwater. Therefore, crystalline waterproofing products resistant to negative water pressure should be preferred. These products form crystals in the concrete and block waterways. However, the timing of application is critical. It should be applied when the concrete is damp. Thus, the material reacts and becomes an effective insulation provides. Sempoly products gives successful results in this regard.

Which Material Should Be Used in Joints and Joints?

In waterproofing The weakest points are joints and seams. Polyurethane-based joint fillers are used in these areas. In addition, joints should be supported with expansion bands. However, the application of these products requires expertise. In case of incorrect application, the sealing feature is lost. By contacting Sempoly the right product and application support can be obtained.

Long Life of Buildings is Provided with the Right Product Selection

The needs of each region are different, so product selection should be made carefully. Also, when the product will be applied is of great importance. The timing of application directly affects the performance of the material. Therefore Sempoly Building Systems It provides correct guidance with its expert staff. Thus, long-lasting and effective waterproofing is provided in the buildings.